Logo
Home
About us
Services
Design examples
Publications & IP
Contact
   
 


Phase I: Proof of concept demonstration of the proposed solution based on design and simulation techniques. This phase also includes due diligence evaluation of regulatory bodies as well as a feasibility study.

Phase II: Prototype performance test against client's specifications.

Phase III: Commercial development, manufacturing, or fabrication through our out sourcing partners.

Our engineering design services include the following areas:


  • Instrumentation and measurement setups
  • Test automation setups
  • Data acquisition
  • A/D converters


  • FPGA, Asic design & design for test
  • DSP algorithms
  • D/A converters
  • RTL coding


  • Linear and non-linear power amplifiers
  • Low noise amplifiers
  • Up and down conversion mixers
  • Voltage controlled oscillators
  • Phase locked loops
  • Injection locked amplifiers
  • Interconnection modeling
  • On-chip passive component modeling
  • High frequency measurement noise modeling
  • Deep submicron device modeling and noise modeling
  • Antenna design


  • Signal integrity and interconnection modeling for high speed circuits
  • Layout design for deep submicron CMOS technology


  • Image sensor design
  • Camera-on-a-chip integration
  • Image sensor noise modeling
  • Array and readout noise modeling
  • Single photon high sensitivity imaging
  • Pixel buffering for high speed imaging


  • Market research
  • Financial planning and budgeting
  • Competitive analysis
  • Project management